MAGICWIN 3D
Briefly Specification
| Outline Dimension | 222(H)mm x 140(V)mm |
|---|---|
| Active Area | 205(H)mm x134(V)mm |
| Mode/Color/Type | Positive/-/OCB |
| Viewing Direction | -, O’CLOCK |
| Viewing Angle | 150 Degree |
| Connector Type | Heat Seal(Not included) |
| Lead-Free Requirement for PIN (Y/N) | N/A |
| Driving IC | – |
| Driv Voltage(VLCD) | ~25.0VOLT(p-p)@ +20 centigrade |
|---|---|
| Operating TEMP centigrade | -10~+60 centigrade |
| Storage TEMP centigrade | -20~+70 centigrade |
| Polarizer Front | H.T. Transmissive (Not included) |
| Polarizer Back | T.T. Transmissive (Not included) |
| Viewing Angle | 176 Degree |
| Back light | Color White |
| Wavelength/Spectrum Intensity/Luminance Glass Type | Circular Polarizer 3D Glass (Single use) |
| Outline Dimension | 222(H)mm x 140(V)mm |
|---|---|
| Active Area | 205(H)mm x134(V)mm |
| Contrast/Ghost | >100:1 |
| Efficiency | 19%@144Hz(Triple Flash Mode) |
| Screen Size | 18m width( Use 6kw Lamp, Silver screen Gain 2.4) |
| Operation Speed | Up to 400FPS (Easily supports new 3D High Frame Rates of 192 and 240 FPS) |
| Actuator | Two-Position rely closure for 2D to 3D |
| 3D Display Mode | LC Filter |
|---|---|
| GPIO Input | D-Sub Jack 37 Pin to Circular connector 4 Pin |
| Signal Output | Circular connector 8 Pin |
| Power Input Voltage | 100~240V(50/60HZ) |
| Power Output Voltage | Adaptor 12V, 5A,60W |
| Power Consumption | Apprx 4W |
Digital Projector for 3D Setting
| frame rate multiplication | 6:2 |
|---|---|
| L/R input reference | Left = PA, Right = PB |
| Input Frame Dominance | Right |
| GPI input | none |
| GPI output (or Display) | none |
| GPO | GPO1 |
| Dark Time | 480 microseconds |
| Output Delay | 0 microseconds |
| Output phase | 0 degrees |
| Output Polarity | True |
| L/R Display Reference | Not Used |